Rig Bar/Panel Assembly - Chauvet Vivid 4 X4 User Manual

Mounting

Rig Bar/Panel Assembly

Alignment Conical (x2)
Spring
Knob
Locking Bar
1. Insert alignment conicals into the alignment holes and allow magnets to connect.
2. Insert the Rig Bar Speego locking bars into the female Speego connections on the Vivid 4.
3. Twist the spring knob on the Rig Bar Speego by 90°, until it locks into place.
4. Twist the tightening knob clockwise until Vivid 4 is secure to Rig Bar.
5. To detach the Rig Bar from the Vivid 4, reverse the previous steps.
• The alignment magnets on the Vivid 4 and F-Series Rig Bar are designed to
temporarily hold the weight of the panel to allow the user to properly align and
tighten the panel into place.
• Either side of the Vivid 4 with female Speego connections can attach to the F-Series
Rig Bar, but only the short side has alignment conicals and magnets. When
attaching the long side of the Vivid 4 to the Rig Bar, take care to ensure that the
pixels across the video assembly are aligned properly.
Warning! The magnetic attachments are not load-bearing, and are intended for
alignment assistance only. Do not release panel until the hanging hardware has been
fully secured.
Vivid 4 X4 User Manual Rev. 1
Rig Bar
Locking Latch
Rig Bar Speego
Tightening
Knob
Alignment Magnets
Alignment Holes
Male Speego Connection
Bottom View
Top View
Rig Bar
Locking Tab
10