Setup; Ac Power; Ac Plug; Power Linking - Chauvet Vivid 4 X4 User Manual

3. Setup

AC Power

Each Vivid 4 has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC,
50/60 Hz. To determine the power requirements for each Vivid 4, refer to the label affixed to the product.
You can also refer to the
The listed current rating indicates the maximum current draw during normal operation. For more
information, download Sizing Circuit Breakers from the Chauvet website: www.chauvetdj.com.
• Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.

AC Plug

Each Vivid 4 comes with a power linking cord to connect power between panels and a power input cord.
This cable has a Seetronic Powerkon
input.

Power Linking

All Vivid 4 panels support power linking. Refer to the following table for specifications on each panel.
Please refer to all applicable local codes and regulations for the proper installation
of this product.
7
Technical Specifications
®
connector to connect to the Vivid 4 and an Edison plug for power
Voltage
@ 120 V, 60 Hz
@ 230 V, 50 Hz
chart in this manual.
Vivid 4 Products
7
13
Vivid 4 X4 User Manual Rev. 1
Setup