Advertisement
TIMETRAX™ SYNC PoE DIGITAL CLOCK
Installation Instructions (cont.)
NON-PoE SWITCH METHOD
Connect CAT-5E Ethernet cable (sold separately) into Ethernet RJ-45 port located on back of clock. If using
standard electrical box mounting method, please advance to step 3.
If not using electrical box, hold security bracket flush against wall, level & mark four screw holes close to
corner tabs. Drill holes as marked and secure bracket to wall using provided screws and wall anchors. Drill
hole centered in square opening of bracket. The hole should be large enough to route Ethernet cable
through wall. Advance to step 4.
If using electrical box, install metal security bracket onto a standard electrical box.
Route the CAT-5E Ethernet cable through the square opening of security bracket, or if preferred pull cable
directly to Ethernet PoE Port Injector (part #APOEPI sold separately). Connect free end of CATE-5E Ethernet
cable into Ethernet Port Injector "LAN +DC" port. Plug Ethernet Port Injector into standard wall outlet.
Push clock onto security bracket aligning four tabs on bracket with four matching slots on back of terminal.
Slide clock downward until locking tab clicks into place. When properly mounted, clock cannot be slid up
and off bracket without using included wall bracket release key to disengage locking tab.
Connect another CAT-5E Ethernet cable (sold separately) into Ethernet Port Injector "LAN" port. Connect
free end of CAT-5E Ethernet cable into Ethernet Switch.
Upon successful connection, clock will display
Run TimeTrax™ Sync software to begin "DEVICE DISCOVERY" and customize configurations. (refer to
software User Guide).
CAT-5E
ETHERNET CABLE
ETHERNET SWITCH
I2253
Page 3 of 5
888.479.7264
pyramidtimesystem.com
SECURITY BRACKET
CAT-5E
ETHERNET CABLE
. Accurate time will display after 1-2 minutes.
DIGITAL CLOCK
Advertisement
