Advertisement
TIMETRAX™ SYNC PoE DIGITAL CLOCK
Installation Instructions (cont.)
PoE SWITCH METHOD
Connect CAT-5E Ethernet cable (sold separately) into RJ-45 Ethernet port located on back of clock. If using
standard electrical box mounting method, please advance to step 3.
If not using electrical box, hold security bracket flush against wall, level & mark four screw holes close to
corner tabs. Drill holes as marked and secure bracket to wall using provided screws and wall anchors. Drill
hole centered in square opening of bracket. The hole should be large enough to route Ethernet cable
through wall. Advance to step 4.
If using electrical box, install metal security bracket onto a standard electrical box.
Route the CAT 5E Ethernet cable through the square opening of security bracket. Pull cable to Ethernet
switch.
Push clock onto security bracket aligning four tabs on bracket with four matching slots on back of terminal.
Slide clock downward until locking tab clicks into place. When properly mounted, clock cannot be slid up
and off bracket without using included wall bracket release key to disengage locking tab.
Connect free end of CAT-5E Ethernet cable into Power over Ethernet Switch (sold separately).
Upon successful connection, clock will display
Run TimeTrax™ Sync software to begin "DEVICE DISCOVERY" and customize configurations. (refer to
software User Guide).
CAT-5E CABLE
I2253
Page 2 of 5
888.479.7264
pyramidtimesystem.com
SECURITY BRACKET
. Accurate time will display after 1-2 minutes.
DIGITAL CLOCK
ETHERNET SWITCH
Advertisement
