Preparing Hot Water; Heating Liquids With Steam - Siemens TK 911N2 Operating Instructions Manual

en
● Dip the tube into a vessel containing milk.
● Remove the small drip tray 11 (up to
around 14 cm in height).
● Place a large glass under the coffee
dispenser 14 and direct the nozzle of the
frothing attachment 9 into the glass.
● Place the Nespresso-capsule on the
lit balcony 16, with the membrane
downwards (Fig. 2).
● Press the button
An optimum mix of frothed milk and coffee
will now automatically fl ow into the cup.
Info: You can halt the dispensing of milk or
coffee respectively at any time by pressing
the button (Cappuccino) or
c
macchiato).
Permanently changing the quantity of
liquid
The preset quantity of milk and coffee for
the preparation of cappuccino and latte
macchiato can be changed.
● Prepare the appliance with milk and
coffee.
● Keep the button
(latte macchiato) depressed until the
desired quantity of milk has been fed
through. During this time
or
Cappuccino
Release the button
(Latte macchiato), and the appliance will
steam briefl y.
● Now keep the button
or (Latte macchiato) pressed until the
d
desired quantity of coffee has been fed
through. During this time
or
Cappuccino
As soon as the process is completed, the
display indicates
Info: If the quantity of coffee is to remain
unchanged, the procedure can also be
ended after changing the quantity of milk.
● Press button (Stand by).
a
appears in the display.
18
(latte macchiato).
d
(latte
d
(cappuccino) or
c
Macchiato
fl ashes in the display.
(Cappuccino) or
c
(Cappuccino)
c
Macchiato
fl ashes in the display.
.
Ready
Ready

Preparing hot water

This function enables hot water to be
prepared, e.g. for a cup of tea.
    
Danger of skin burns
!
The nozzle becomes very hot, and
should only be grasped by the plastic
section.
● Screw the nozzle 10 onto the adapter 8 of
the steam pipe 7 (Fig. 3).
● Hold a glass or cup under the nozzle 10.
● Press button
Hot water is dispensed from the nozzle
10.
● To stop, press the button
again.
appears briefl y in the display.
Wait
The display then indicates
more.
Heating liquids with
steam
    
Danger of scalding
d !
Steam is very hot, and may cause the
liquid to splutter.
● Screw the nozzle 10 in place (Fig. 3).
● Press the steam button
and
d
Steam
display.
As soon as
alternately in the display, steam can be
drawn off.
● Immerse the nozzle 10 deeply into the
liquid, making sure it does not touch the
bottom of the vessel.
● Press button
● Slowly trace circles through the liquid in
the vessel. The liquid is heated up.
● As soon as the liquid is hot, press button
(steam) once again.
h
The display alternates between
.
ready
The appliance now automatically cools
down for around 2 minutes. The display
once again indicates
(hot water).
g
(hot water)
g
Ready
.
h
fl ash alternately in the
wait
and
Steam ready
(steam).
h
.
Ready
once
fl ash
and
Steam