Trap Assembly - Champion SKYBIRD Owner's/Operator's Manual

Tubes Front Tube Support (H)
Tubes
Connect
Connect
STEP 1.
TRAP BODY TO TRIPOD (FIG-3)
Mount pivot mount (C) to the trap using the 12 MM X
35 MM Lg. Hex Bolt (K-1). Orientate the Pivot Mount
(C) so that the serrated face of the Pivot Mount faces
to the right as shown. Pivot the trap slightly above
horizontal and tighten the hex bolt securely. This
setup will provide a good starting point for target
launch direction. Attach Trap Body Handle (L) to Trap
Body using bolt (K-17) and washer (K-18). Front of
Trap Body Handle fits under top of trap body into slot
and is then bolted to Trap Body.
Attach Trigger (M) to tab on Trap Body (B) using 2
Bolts (K-16).
STEP 2.
TUBE SUPPORT ASSEMBLY (FIG-3)
Insert two 6 MM X 90 MM Lg. Hex Head Bolts (K-8)
through holes in the short Rear Tube Support (K-11),
through holes in sides at rear of Trap Body (B) and
through second Rear Tube Support (K-11). Attach 6
MM Flange Nuts (K-9).
Attach Front Tube Supports (H) to front of trap
following the same steps using the same size Hex
Head Bolts (K-8), and 6MM Flange Nuts (K-9).
TRAP ASSEMBLY – TRIPOD MOUNT
Front Tube Support (H)
6 MM X 90 MM
6 MM X 90 MM
Hex Bolts
(K-8)
Tubes
Connect
Trap Body (B)
Tubes
Connect
Hex Bolts
(K-8)
5 ->!3!-
12 MM X 35 MM
*45 -, !
Hex Bolt
(K-1)
6
Arm Path Indicator Tubing (I)
6 MM
Trigger (M) &
Flange Nuts
6MM x 12MM Lg. Bolts (K-16)
(K-9)
Flange Nuts
Eyebolt
(K-14)
Rear Tube
Support (K-11)
7(82A!
K%))2H& !
Trap Body Handle (L)
Pivot
*+, !
Mount (C)
SEE TRIPOD PIVOT
MOUNT TOP PLATE (J-5)
Attach Eyebolt (K-14) to return spring
hole in trigger plate as shown using
nuts (K-12, K-13). Attach Trigger String
(K-15) to eyebolt (K-14) to use string to
release trap. (FIG-7).
MAKE SURE WARNINGS ON FRONT
TUBE SUPPORTS ARE UPRIGHT. Tighten
all four nuts on Tube Supports securely.
Slide three pieces of Arm Path Indicator
Tubing (I) over ends of Front Tube
Supports (H) and Rear Tube Supports (K-
11). This ring indicates the approximate
path of the Throwing Arm (A).
6 MM
(K-9)
!
Tubes
Connect
6MM x 24MM
Hex Bolt &
M6 x 18mm
Washer
(K-17 & K-18)
FIGURE 3