Projector Setup - Toshiba TDP-TW95E Service Manual

Projector Setup

Plug in the power cord; turn on main power switch and the power of the projector.
How to enter to the Factory Mode (TDP-TW95/TW100)
1) While the Volume adjustment bar is displayed on the screen, set value to [1],
and press the buttons,
[Input], [On/Standby] and [Keystone] simultaneously.
2) While the Volume adjustment bar is displayed on the screen, set value to [0],
and press the buttons,
[Input], [On/Standby] and [Keystone] simultaneously.
3) While the Volume adjustment bar is displayed on the screen, set value to [0],
and press the buttons,
[Input], [On/Standby] and [Keystone] simultaneously.
How to display the Service status
After the projector has entered to the factory mode, press the buttons,
[Return] and [Up] simultaneously. Then, the following display appears.
If it doesn't appear, repeat from the beginning.
This mode maintains until you turn off the Main power switch.
FAN-1 is Z100 (Service part location No.). FAN-2 is Z101.
FAN-3 is Z102. FAN-4 is Z104. FAN-5 is Z103.
Temp-1 is Intake temperature at Sensor Board.
Temp-2 is lamp nearby temperature.
A number of Error log means an error ID
.
7-3
Chapter 7