Projector Setup - Toshiba TLP-X2500C Service Manual

Projector Setup

Plug in the power cord; turn on main power switch and the power of the projector.
How to enter to the Factory Mode (TLP-X2500/XC2500/X3000/XC3000)
1) While the Volume adjustment bar is displayed on the screen, set value to [2],
and press the buttons,
[Input], [On/Standby] and [Keystone] simultaneously.
2) While the Volume adjustment bar is displayed on the screen, set value to [0],
and press the buttons,
[Input], [On/Standby] and [Keystone] simultaneously.
3) While the Volume adjustment bar is displayed on the screen, set value to [0],
and press the buttons,
[Input], [On/Standby] and [Keystone] simultaneously.
4) While the Volume adjustment bar is displayed on the screen, set value to [0],
and press the buttons,
[Input], [On/Standby] and [Keystone] simultaneously.
When the projector enters to the Service Mode, the buzzer beeps for 3 seconds.
If doesn't beep, repeat from the beginning.
This mode maintains until you turn off the main power switch.
7-3
Chapter 7