Fluke 28 II Ex Getting Started Manual page 22

28 II Ex
Getting Started Manual
Replace the batteries as follows, refer to Figure 3:
1. Turn the rotary switch to OFF and remove the test
leads from the terminals.
2. Remove the six Torx-head screws from the case
bottom and remove the battery door ().
When you lift the battery door, make sure the
rubber gasket stays attached to the battery
compartment barrier.
3. Remove the three batteries and replace all three with
AAA Alkaline batteries ().
4. Make sure the battery compartment gasket () is
properly installed around the outside edge of the
battery compartment barrier.
5. Align the battery compartment barrier with battery
compartment while you replace the battery door.
6. Attach the door with the six Torx-head screws.
It is recommended the batteries be removed
from the Product for long periods of storage.
18
Note
Note