Installation And Recognition Confirmation Of Options - Oki C810 Maintenance Manual

Oki Data CONFIDENTIAL

3.5.3 Installation and recognition confirmation of options

(1) Installation of an additional tray unit
An additional tray unit is intended for increasing the amount of paper that can be loaded in
the printer, and two additional tray units can be installed to the printer. An additional tray holds
530 sheets of 70 kg paper, allowing the printer to print up to 1,460 sheets continuously when
used with a standard paper cassette and a multi-purpose tray together.
1. Turn off the printer and disconnect the power cord.
Turn off the printer by following the steps described under "Turning off the power" in
section 3.5.2.
Note! • Turning off the power without taking proper shutdown steps may cause a
failure of the printer, so be sure to run [SHUT DOWN MENU].
• Installation of an additional tray unit with the power on may cause a failure
of the printer.
44072903TH Rev.1
2. Place the printer on an additional tray unit.
Note! The printer weights approximately 40 kg. It should be lifted by two or more
people.
Align the holes on the bottom of the printer to the pins of the additional tray unit.
Place the printer gently on the additional tray unit.
To detach the additional tray unit, follow the same procedure in reverse order of
installation.
Hole on the bottom of the printer
Pin
3. Connect the power cord and the printer cable to the printer and
turn the power ON.
Note! If [SERVICE CALL 182: ERROR] appears, remove the installed tray unit
and reinstall it to the printer.
3. INSTALLATION
Note! To install two additional tray
units to the printer, make them
stacked before installation to
the printer.
42 /