Oki C810 Maintenance Manual page 175

Oki Data CONFIDENTIAL
JAM RELEASE METHOD ②
FUSER unit section (Codes: 381, 382, 383,385)
Caution
The fuser unit can be very hot. Be careful not to touch it. If the unit remains
hot, do not hasten to work, but wait, until after the unit has cooled down a
little, and then remove the paper.
(1) Raise the lock levers (blue) of the fuser unit in the direction of the arrows.
(2) Take out the fuser unit holding it by the handle, and place it on a flat table.
Fuser unit
Locking lever (blue)
(3) Pull the jam release levers (two places) up and pull the jammed paper slowly in
the arrow direction (toward you).
Jam Release Lever
44072903TH Rev.1
Personal injuries may occur.
Handle
(4) Hold the fuser unit again by the handle and put it gently back in the printer.
(5) Push the lock levers (blue) of the fuser unit toward the rear, and fasten the unit.
Fuser Unit Locking lever
(blue)
Note! After a jammed paper has been removed from the fuser unit section,
unfixed toner may still remain inside the fuser unit. Therefore, execute the
Menu Map print (Subsection 3.6), or print blank paper several times.
If the paper jam error is not cleared even after the jammed paper has been removed,
remove the other jammed paper by the procedure described below.
(1) Discharge static electricity by touching the screw by hand.
7. TROUBLESHOOTING PROCEFRURES
Handle
Screw
175 /