Table of Contents
Advertisement
ENGLISH
N.B. The water softener is indispensable for correct operation of the appliance, to optimise coffee delivery in the cup and to extend the working life
of components, as it purifies the water from limescale and residues that would otherwise shorten working life.
Failure to follow these instructions absolves the company from all liability.
Before connecting the pump intake tube, open the tap and run water through the water softener for about two minutes to eliminate possible.
IMPURITIES FILTER
The impurities filter (code 10355150) is normally mounted on the hose connecting the purifier to the pump (fig. A) to prevent impurities in the
water from damaging downstream components
such as the pumping head, flow pumps, solenoid
valves, etc.
The capsule filter (code 10355162) which blocks
the impurities present in the water must be replaced
about every three months.
The three month period is indicative only as the
actual length of time is correlated to water con-
sumption and the impurities present in the mains
water supply.
To replace the capsule filter: contact SANREMO cu-
stomer services.
USE
PRELIMINARY CHECk
Before using the appliance, check that:
- the plug is inserted properly into the mains power outlet;
- the water filling hose is correctly connected to the mains water outlet, check for leaks and that the water tap is open;
- the drain pipe is positioned in accordance with the preceding instructions.
With the steam tap (B) open, place the ON/OFF switch (D) in the 1 position and wait for the water in the boiler to reach the maximum level
established by the electronic control unit. If the boiler does not fill within the set time-out (90 secs.), the pump stops and the keypad LEDs flash.
In this case put the on/off switch (D) to position 0 and then to position 1 to finish filling the boiler.
Now put the on/off switch (D) to position 2 so that the heating elements are powered and therefore start to heat the water.
Wait for steam to come out the steam nozzle (B), then close the tap and, using the Boiler pressure gauge, check that the pressure has reached and
maintains a value of 0.8:1 bar.
HOT WATER DELIvERY
Make sure the boiler pressure gauge shows a pressure of 0.5:1 bars.
Press the button (M6) to deliver hot water, then press again to stop delivery.
Take great care to avoid burns.
STEAM DELIvERY
All models have two steam nozzles on the sides of the work surface, with the exception of the one group machine which has just one. These
steam nozzles are retractable and can be oriented by means of a ball joint. To deliver steam, turn the knobs (B) anticlockwise. Take great care to
avoid burns.
COFFEE DELIvERY ZOE SAP MODEL
Insert the filter holder (E) into the group head (F) turning the filter holder counter-clockwise. Press the button (M5) and wait for the required quantity
of coffee to be dispensed, press it again.
COFFEE DELIvERY ZOE SED MODEL
Insert the filter holder (E) in its seat (F) by turning it anticlockwise. Select the type of delivery required on the keypad (M):
M1=One short/standard coffee.
M2=One standard/long coffee.
M1=Two short/standard coffees.
M4=Two standard/long coffees.
M5=Electronic settings button or continuous manual delivery.
Before use, the operator must always check the indicator (L) to make sure that the level of water in the boiler is above the minimum level.
5
Hide quick links:
Advertisement
Table of Contents
