2.5.2
Installing an ASUS PIKE II card
You may install an ASUS PIKE II card to the internal SAS/HBA/Storage bracket located in the
front of the system or the riser bracket located in the rear of the system.
To install an ASUS PIKE II card to the front of the system (ESC4000 G4 only):
1.
Remove the default cable from the motherboard and the backplane.
2.
Remove the screw from the bracket (A), then push the internal SAS/HBA/Storage
bracket towards the rear to remove the internal SAS/HBA/Storage bracket (B).
2-20
Chapter 2: Hardware Setup