Front Mounting A K Chassis - Enterasys K6 Installation Manual

Installing the K Chassis

Front Mounting a K Chassis

To install the K6 chassis in a rack using the K6 chassis front mounting brackets:
1. Lift the chassis and slide it all the way into the rack until the front mounting brackets are
against the front of the rack posts.
2. Use 6 screws (3 per side) to secure the chassis to the rack, starting with the bottom holes and
working toward the top of the chassis. See Figure
Figure 3-3
3-6 Chassis Setup
Caution: Read Chapter 2
guidelines are met.
Precaución: Antes de llevar a cabo el siguiente procedimiento, lea
de cumplir con todos los requisitos de instalación.
Warning: To help prevent personal injury, at least two people are required to lift the chassis into
the rack.
Advertencia: Para ayudar a prevenir alguna lesión personal , al menos dos personas son
requeridas para levantar el chasis y meterlo al rack.
Warnhinweis: Zum Schutz vor körperlichen Schäden, sollten sie mit min. zwei Personen das
Chassis in das Rack heben.
Note: Refer to Table A-4 on page A-2 for recommended torque values to use when installing the K6
chassis using standard threaded fastener machine screws and bolts.
Front Mounting the K6 Chassis in a Rack
before completing the following procedure to ensure that all installation
3‐3.
Chapter 2 para y asegúrese