Precautions - AEMC 1822 User Manual

Thank you for purchasing the Model 1821 or Model 1822 thermocouple thermometer data logger, or Model 1823
resistance thermometer data logger. For best results from your instrument:

read these operating instructions carefully

comply with the precautions for use
WARNING, risk of DANGER! The operator must refer to these instructions whenever this
danger symbol appears.
Information or useful tip.
Battery.
Magnet.
The product has been declared recyclable after analysis of its life cycle in accordance with
the ISO14040 standard.
AEMC has adopted an Eco-Design approach in order to design this appliance. Analysis of
the complete lifecycle has enabled us to control and optimize the effects of the product on
the environment. In particular this appliance exceeds regulation requirements with respect
to recycling and reuse.
Indicates conformity with European directives and with regulations covering EMC.
Indicates that, in the European Union, the instrument must undergo selective disposal in
compliance with Directive WEEE 2002/96/EC. This instrument must not be treated as
household waste.

Precautions

This instrument is compliant with safety standard IEC 61010-2-030, for voltages up to 5V with respect to ground.
Failure to observe the following safety instructions may result in electric shock, fire, explosion, and damage to
the instrument and/or the installation in which it is located.

The operator and/or the responsible authority must carefully read and clearly understand the all
precautions to be taken in use. Thorough knowledge and awareness of electrical hazards are essential
when using this instrument.

Observe the conditions of use, including temperature, relative humidity, altitude, degree of pollution, and
place of use.

Do not use the instrument if it appears damaged, incomplete, or poorly closed.

Before each use, check the condition of the housing and accessories. Any item on which the insulation is
deteriorated (even partially) must be set aside for repair or scrapping.

Do not take measurements on bare live conductors. Use a non-contact or properly insulated sensor.

Always wear personal protective equipment (PPE), in particular insulating gloves, if there is any doubt about
the voltage levels to which the temperature sensor is connected.

All troubleshooting and metrological checks must be done by competent, accredited personnel.
4 Thermometer Data Logger Models 1821, 1822, 1823