Ruckus Wireless ZoneFlex 7372-E Quick Setup Manual page 3

(O ) M I
PTIONAL OUNTING NSTRUCTIONS
The ZoneFlex 7372-E can be mounted to a wall, ceiling or to a T-
bar using the supplied mounting screws or the T-bar clips built
into the bottom of the AP enclosure.
Mounting to a Flat Surface
1
Use this Quick Start Guide template or the alignment spacer
to mark the locations for screw holes on the mounting sur-
face. Use a 5mm drill bit to drill approximately 25mm into
the mounting surface.
2 Insert the anchors and mounting screws into the mounting
surface, leaving approximately 0.28" (7 mm) of the screw
heads protruding for the AP enclosure.
The screws should be approximately 3.25" (82.6 mm) apart
per the template.
3 Insert a straightened paperclip (or similar) into the hole on
the side of the AP ( Figure 1. ), to release the locking mecha-
nism.
Figure 1. Insert a paperclip into the pinhole
Hold paperclip in
while mounting
4 Place the AP onto the mounting screws so that the screw
heads enter the mounting holes on the AP enclosure, and
push the AP downward to lock in place.
5 Remove the paperclip to release the lock mechanism and
secure the AP.
6
To unmount, insert a straightened paperclip into the hole on
the side of the AP to unlock, then push the AP upward to
release the AP enclosure from the mounting screws.
Mounting to a T-Bar
The ZoneFlex 7372-E provides mounting options for flush tile
and recessed frame T-bars in acoustical ceiling tiles.
Flush Tile
1
Orient the AP so that the T-bar is positioned between the T-
bar clips as shown in Figure 2. , then rotate the AP until the
third T-bar clip catches the T-bar and the latch locks the T-bar
Figure 3.
in place ( ).
Copyright © 2013 Ruckus Wireless, Inc.
Published June 2013, Part Number 800-70494-001 Rev B
Figure 2.
Figure 3.
2
For added security, insert the Torx-head security screw into
the security screw hole shown in Figure 3.
3 To remove the unit, first remove the security screw, then
depress the latch while rotating the AP so that the T-bar clips
disengage the T-bar.
F M I
OR ORE NFORMATION
You can now use the wireless network to log into the AP's Web
interface. Use the Web interface to review and fine-tune a wide
range of AP settings. For information on how to configure the AP
from the Web interface, refer to the Ruckus Wireless ZoneFlex
Indoor Access Point User Guide or the Online Help, available
from within the Web interface.
Security screw
hole
Page 3 of 4