Jump Starting; Charging The Jumpstarter; Ac Charging - Projecta LS950 Manual

VEHICLE JUMPSTARTING INSTRUCTIONS
1. Your Jumpstarter should be charged for 8 hours prior to first use and as soon as
possible after each use.
2. Before making any connections, check the Jumpstarter battery status by turning on the
Jumpstarter. The Jumpstarters battery capacity should show at least 2 bars or
50% charged.
3. Turn your vehicle's ignition OFF before connecting the Jumpstarters clamps to your
vehicle.
4. Connect the Red Positive (+) clamp to the positive (+) terminal of the battery in the
vehicle and the Black Negative (-) clamp to the negative (-) terminal of the battery
or any non moving metal part of the engine block. DO NOT CONNECT TO FUEL LINE.
Always double check that you have the proper connections.
At this point the clamp voltage (vehicle voltage) will be displayed on the jumpstarter.
5. Press the Jumpstart button.
If the vehicle voltage is less than 2.5V. You will need to engage OVERRIDE on the
jumpstarter. To do this you will need to press the POWER/LIGHT button and JUMPSTART
button together for more than 3 seconds.
If the Jumpstarter fails to start your vehicle refer to the Jumpstarter display for any
errors it may indicate & check that the clamps are correctly connected with good
contact.
6. Turn the vehicle's ignition to ON and start the vehicle. After the engine has started,
turn the Jumpstarter off.
7. Disconnect the Black clamp and then the Red clamp.
8. Recharge the Jumpstarter.

CHARGING THE JUMPSTARTER

The Jumpstarter can be charged with the provided 240V A.C adaptor or by the 12V D.C
Cigarette plug adaptor.

AC CHARGING

1. Plug the AC charger into the Jumpstarters charing port.
2. Connect the AC charger to the mains supply. The LCD will now display CHARGING.
3. When the battery is charged the LCD display will show FULLY CHARGED and the jumpstarter
will stop charging.
4. Disconnect the AC charger from mains supply and unplug the charger from the Jumpstarter.
66