Emerson FreezeAlarm FA-I-CCA User Manual page 9

5. Plug in your standard, single line telephone to the "PROGRAM PHONE" jack
on the front of your FreezeAlarm. See Figure below.
FA-I-CCA
2.0 PROGRAMMING:
You can program your FreezeAlarm using a regular home telephone or you can
remotely access your FreezeAlarm and program it using a cell phone or a phone at
another location. This feature allows you to remotely change programming selections
at a later time from any phone in the world. Most first time users program their
FreezeAlarm locally, or at the location where the FreezeAlarm is located by using a
single line home telephone. A cordless phone may work, but a standard single line
home telephone with a wired handset will work best. An explanation of each menu
option with helpful hints on programming is provided after the quick programming
guide.
2.1 Quick Program:
If you feel comfortable with the various menu options and want to get your
FreezeAlarm up and running quickly, follow the steps below. This provides a quick
method to program up to three call-to phone numbers into your FreezeAlarm in just a
few minutes. You should program at least one call-to telephone number into your
FreezeAlarm for proper operation. Check the factory defaults if you need to change
any other settings as they are not discussed in this Quick Program section. When the
manual tells you to press a number, it is referring to a number on your program
telephone's keypad. If you need an explanation of each menu option, please go to the
next section starting on page 10.
1. Make sure the dip switches on the back of the FreezeAlarm are set properly for
your application. See the dip switch table earlier in this manual for switch
explanations.
2. Make sure your FreezeAlarm is connected properly and has a 9 volt lithium battery
installed.
3. Check to be sure the toggle switch on the front of the FreezeAlarm is set to
STANDBY position. The front ALARM light will blink while in STANDBY
mode.
4. Plug a program phone into the PROGRAM PHONE jack on the front of the
FreezeAlarm.
5. Pick up the telephone handset and the Main Menu will begin to play.
6. Press 2 to access the Program Menu.
7. Press 1 to review or program phone numbers.
This phone will only be used to
program your FreezeAlarm locally or
for locally checking current status of
your FreezeAlarm. It is important to
UNPLUG this phone from the front
after you are done programming or
making any changes.
9