Table of Contents
Advertisement
Flush-front mounting
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
NOTE
The illustrations in the rack installation procedures are for reference only and may not show the device that you are installing.
Complete the following tasks to install the device in a four-post rack.
1.
Attaching the front brackets
2.
Attaching the bracket extensions to the device
3.
Installing the device in the rack
4.
Attaching the rear brackets to the extensions
5.
Attaching the rear brackets to the rack posts
Attaching the front brackets
Complete the following steps to attach the front brackets to the device.
1.
Position the right front bracket with the flat side against the right side of the device at the front of the device, as shown in
17.
2.
Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on the
side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3.
Repeat step 1 and step 2 to attach the left front bracket to the left side of the device.
Brocade 7840 Extension Switch Hardware Installation Guide
53-1003127-10
on page 33
on page 34
on page 35
on page 36
on page 37
Installing the Universal Four-Post Rack Kit (XBR-R000296)
Figure
33
Advertisement
Table of Contents
