Advertisement
PANEL FACILITIES
-AC IN
Connect this to a wall socket ( 1 20 or 220-240V AC,
50/60Hz) using a triple-conductor power cord. A suitable
cord should be obtained from your dealer.
VOLT AGE SELECTOR ( 120V /220-240V AC)
Used to change the operating voltage of the player.
Set the selector to the mains voltage in your area.
VIDEO OUT terminals
(RCA jack, BNC jack)
VOLIA(,f
HcECTOD
RGSOUT
~
These terminals are connected to the video input jack of the
TV monitor. The same signals are output from both terminals.
RGB terminal (D-SUB 9 pin)
Used for connection to the RGB monitor.
1.
GND
9 8 7 6
2.GND
3.
RED
4. GREEN
5.
BLUE
1 2 3 4 5
6.NC
7.NC
8. Composite
sync.
9. PAL/NTSC
(PAL=
H/NTSC
=
LI
EXT SYNC termination selector
This switch is used for selecting whether the signal input to
EXT SYNC IN is given 75 Q termination within the player (ON
position), or looped through (OFF position).
EXT SYNC IN. OUT terminals (BNC jacks)
IN :
Connects to the sync generator in the event that
the main unit is operated in external sync mode.
O.(OUT) : Can be connected to EXT SYNC IN terminal of se-
cond player.
NOTE:
• Set the EXT SYNC termination selector in accordance with
the conditions of use.
AUDIO OUT terminals (RCA jacks)
For connection to a stereo amplifier (LD, AUX etc.)
EFM OUT terminal (5 pin DIN)
J~:
To connect an LD-ROM adaptor.
1. PAL/NTSC (PAL=H/NTSC=L)
2. GND
3.
Audio L (ON=H/OFF=L)
4.
EFM
5. Audio R (ON=H/OFF=L)
RS-232C INTERFACE CONNECTOR
(D-SUB 15 pin)
2
Used for serial interface connection to a computer or con-
troller. See page 12 for details.
9
<DRE1006>
En
Advertisement
