Advertisement
LASERDISCS
After using discs, store them vertically upright
After playing a disc, always remove it from the player and return
it to its jacket. Then store it standing vertically upright away from
heat and humidity.
• Take care when storing discs. If you store discs at an angle, or
stacked on top of each other, discs may become warped even
when in their jackets.
• Do not leave discs in locations such as the seat of car, which
may become unbelievable hot.
If a disc becomes warped, put the disc into its protective enve-
lope, and then place it between flat plates made of glass etc.
Then place thick books etc. on top of the plates so as to apply a
weight of 4 to 5 kg (9 - 1 1 lb), and leave the disc like this for a
day or so. This may alleviate the warp.
Thick books etc. (4 - 5 kg/9 - 11 lb)
/-
.
~ - ~ = ~ - G l a s s plate etc.
D 1 s c ~ O ) ~
i ~
Protective
Glass plate etc.
envelope
CAUTION WHEN USING THE DISC
All rights reserved.
Unauthorized public performance, broadcasting or copying is
a violation of applicable laws.
CONNECTIONS
(See page
5)
NOTE:
Leave the player and TV monitor unplugged while
connections are being made.
8
<DRE1006>
En
CONNECTIONS
[Fig.~]
Before making or changing the connections. switch off
the power switch and disconnect the power cord from
the
AC
outlet.
G)
Stereo Amplifier
(Z)
Auxiliary audio cords
@
-AC in
@
Can be connected to LD-ROM adaptor
@
Auxiliary video cord
@
RGB monitor
(J)
TV monitor (PAL or NTSC)
®
Host computer (controller)
®
Interface cable
Interface cable
Please use cable with pins arranged exclusively for player con-
trol. Ask your dealer for this cable.
D-SUB 1 5 pins
(to this player)
D-SUB 25 pins female type
(to the controller)
EXTERNAL SYNCHRONIZATION OF THE PLAY-
BACK VIDEO IMAGE
[Fig.
@1
The composite sync from the external sync generator are used
for external synchronization -of the playback video image (EXT
SYNC MODE).
When multiple LaserDisc players or other video components are
used simultaneously and synchronization is taken from the same
sync generator, the playback images can be switched without dis-
rupting the synchronization on the monitors.
The sync generator's composite output
(3
Vp-p or more and less
than
4.5
Vp-p,
75
Q
sync. negative) is connected to the player's
EXT SYNC IN terminal.
NOTE:
• External synchronization is possible only during CA V disc play-
back.
• Use PAL or NTSC sync generator or a generator with compati-
ble specifications.
If
jitter and noise are contained in the exter-
nal synchronizing signal, the player may not operate properly.
• Switch to the external synchronization mode while the player
is in the set up mode. Error will occur if the composite sync sig-
nal enters the EXT SYNC IN after playback started, or the input
to the EXT SYNC is interrupted during playback in external syn-
chronization mode.
G)
Can be connected to EXT SYNC IN terminal of the second play-
er. In this case, set the
75
n
switch to "OFF."
(2)
PAL or NTSC sync. generator
®
•When using the EXT SYNC IN terminal only · · · Set to ON.
•When also using the EXT SYNC OUT terminal ·· · Set to OFF.
Advertisement
