Advertisement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 1 5 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener-
ates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.
[For Canadian model]
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment.
To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for
connections.
LINE VOLTAGE SELECTOR SWITCH
A 2-Point ( 120V /220-240V) voltage selector switch is locat-
ed on the rear panel of the player.
Check that it is set properly before plugging the mains lead
into an AC outlet. If the voltage is not properly set or if you
move to an area where the voltage supply differs, adjust the
selector switch as follows:
1. Disconnect the mains lead.
2. Use a medium-sized (flat blade) screwdriver. Insert the tip
of the screwdriver into the groove of the selector switch
and turn it to set the player to the power voltage of your
area.
Point arrow to power voltage of your area (Figure shows
arrow pointing to 120 volts.)
4
<DRE1006>
En
I 20V
N
220 · 240V
VOLTAGE
SELECTOR
Use discs bearing the following mark with your player.
ee
laserVision
LASER DISC
This is the standard LaserVision system mark. This LaserVi-
sion mark certifies compatibility with other laser optical video
products bearing the same mark.
MAINTENANCE OF EXTERNAL SURFACES
• Use a polishing cloth or dry cloth to wipe off dust and dirt.
• When the surfaces are very dirty, wipe with a soft cloth dipped
in some neutral cleanser diluted five or six times with water,
and then wipe again with a dry cloth. Do not use furniture wax
or cleaners.
• Never use thinners, benzine, insecticide sprays and other
chemicals on near this unit, since these will corrode the sur-
faces.
Advertisement
