Installation And Configuration - Riello NetMan 202 plus User Manual

INSTALLATION AND CONFIGURATION

I
NSTALLATION OF
1. Remove the cover of the UPS expansion slot by removing the two retaining screws.
2. Insert NetMan 202 plus in the slot.
Connect the device to the network by means of connector RJ-45 (see "Specifications for
3.
the cabling of the network cable")
4. Secure Netman in the slot using the two screws removed previously.
C
ONFIGURATION
NetMan plus can be configured via usb or via ssh.
NetMan plus needs approx. 30 seconds to become operational from when it is powered
up; before this time the device may not respond to commands that are sent to it
Configuration via USB
To configure NetMan plus via USB, it is necessary to:

Connect, with the USB cable provided, the micro-USB port with the USB port of the PC

execute the software HyperNetman

press the "Enter" key of the PC

at the login prompt, enter "admin"

at the password prompt, enter the current password (default configuration: "admin")
During password's typing, no character is shown.
Once login has been effected, the screen of the start menu is displayed. From this screen it is
possible to access the various menus to change NetMan plus settings (see paragraph "Main
configuration menu" and following paragraphs).
Note: at the first login it is necessary to access with user admin (see chapter "Users").
Configuration via ssh
To configure NetMan plus via ssh it is necessary to:

execute a ssh client on a PC connected in a network to NetMan plus set with the IP
address of the device to be configured

at the login prompt, enter "admin"

at the password prompt, enter the current password (default configuration: "admin")
During password's typing, no character is shown.
- ENGLISH -
N M 202
ET AN PLUS
- 16 -