Assembly - ProForm 795 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver
1. Note: One person must hold the Console Base (91)
near the Upright (71) during steps 1, 2, and 3. If this
is not done, the wire harness connecting the con-
sole to the treadmill may be permanently damaged.
Hold the Console Base (91) near the Upright (71).
Refer to inset drawing A. Remove the indicated Ground
Screw (61) from the Upright (71). Slide the metal eye-
lets on the two ground wires onto the Ground Screw.
Tighten the Ground Screw into the Upright.
Refer to inset drawing B. Connect the Wire Harness
(85) to the Console Wire Harness (120). Connect the
54" Hand Pulse Wire (95) and the 25" Hand Pulse Wire
(83) to the 39" Wire Harness (77) (make sure that the
Wires with tags are connected to each other).
2. Slide the Left and Right Base Mounts (104, 78) onto
the plastic pins on the sides of the Console Base (91).
Next, carefully insert the Left and Right Base Mounts
(104, 78) into the Upright (71) as shown.
Refer to the inset drawing. Carefully feed all wires into
the hole in the Upright (71) as shown. Make sure that
the wires are routed through the notch in the base
mount and under the plastic pin. Be careful not to pull
on the wires or they may become disconnected
from the console.
3. Slide the Left and Right Lower Base Mounts (105, 79)
onto the Left and Right Base Mounts (104, 78). Attach
the Lower Base Mounts with eight 3/4" Screws (77) as
shown. Be careful not to overtighten the Screws.
(not included).
1
A
61
71
Ground Wires
2
104
Pin
Notch
71
3
104
105
77
5
91
71
B
85
120
95
77
83
91
78
71
78
79
77