Installing the base cover
1
Place the base cover to align with the screw holders on the system.
2
Tighten the 8 captive screws to secure the base cover to the system.
3
Follow the procedure in
Battery
Removing the battery
1
Follow the procedure in
2
Remove the
base
cover.
3
To remove the battery:
a
Disconnect the battery cable from the connector on the system board [1] and unroute the cable from the routing channel.
b Loosen the single (M2x6) captive screw that secures the battery to the system [2].
c
Lift the battery away from the system [3].
Installing the battery
1
Insert the battery into the slot on the system.
2
Route the battery cable through the routing channel.
14
Removing and installing components
After working inside your
computer.
Before working inside your
computer.