Connecting The Idsl Line Driver V.35 Serial Interface - Black Box ME0002A-V35 User Manual

IDSL LINE DRIVER W/V.35 OR X.21

4.2 Connecting the IDSL Line Driver V.35 Serial Interface

The IDSL Line Driver supports V.35 serial port connections. This section describes
how to connect the serial ports to your V.35 equipment.
4.2.1 C
ONNECTING THE
The Line Driver provides a V.35 DCE (Data Circuit Terminating Equipment)
interface on an M/34 female connector. As a DCE, this interface is designed to
connect to DTE equipment, such as a router. When connecting the V.35 interface
of the Line Driver to your DTE device, use a V.35 straight-through cable (see
Figure 4-3). Appendix A describes pin assignments and signal sources for the Line
Driver's V.35 interface. When purchasing or constructing an interface cable, please
use Appendix A as a guide.
IDSL Line Driver
(ME0002A-V35)
Figure 4-3. Connecting the Line Driver to a V.35 serial DTE.
18
Figure 4-2. RJ-45 twisted-pair interface.
IDSL L D
INE RIVER
DSL span
IDSL Line Driver
(ME0002A-V35)
- - - - - - - - - - - - - - - - - 1 Not connected
- - - - - - - - - - - - - - - - - 2 Not connected
- - - - - - - - - - - - - - - - - 3 Not connected
- - - - - - - - - - - - - - - - - 4 (2-wire Tip)
- - - - - - - - - - - - - - - - - 5 (2-wire Ring)
- - - - - - - - - - - - - - - - - 6 Not connected
- - - - - - - - - - - - - - - - - 7 Not connected
- - - - - - - - - - - - - - - - - 8 Not connected
V.35 DTE D
TO A EVICE
Straight-through
M/34 cable
V.35 router (DTE)