Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver
wrench
, and a rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. IMPORTANT: Some small parts may have been
pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. If a part is
missing, call 1-888-533-1333.
M8 Nylon
Locknut (96)–4
M4 x 16mm
M4 x 16mm
Screw (86)–4
Self-tapping
Screw (79)–10
M4 x 65mm Screw (91)–4
M6 x 16mm Phillips
Patch Screw (87)–8
M10 x 15mm Patch
Screw (82)–10
M6 Split
M10 Spacer
Washer (88)–8
M4 x 16mm
Flange Screw
(84)–2
M8 x 16mm Patch
Screw (95)–3
M10 x 48mm Patch Screw (78)–2
M10 x 35mm Shoulder
Patch Screw (94)–2
.
M10 Split
(76)–2
Washer (72)–2
M4 x 12mm
Flange Screw
(73)–6
M10 x 20mm x
2mm Washer
M8 x 42mm Button Bolt (71)–4
M10 x 62mm Patch Bolt (97)–2
5
, an adjustable
Wave Washer
(93)–6
M10 x 25mm x
1.5mm Washer
(81)–2
(83)–10
M10 x 23mm Shoulder
Patch Screw (80)–2
Advertisement
Table of Contents
