Stopping Procedure - Hyundai HY8500 Hirepro User Manual

STOPPING PROCEDURE

4.8 Turn 'OFF' and unplug all appliances attached to the machine.
4.9 Allow the engine to run at idle for a minute.
4.9 Turn the engine switch to the 'OFF' position.
4.10 Turn OFF the fuel tap.
5. USING THE MACHINE
CAUTION
Make sure the electrical apparatus to be powered is turned 'OFF' before plugging
into the socket outlet.
CAUTION
DO NOT overload the generator.
DO NOT overload individual sockets.
5.0 Overloading a generator in excess of its rated wattage capacity can result in damage
to the generator and to prevent overloading of the circuit.
5.1 Add up to total wattage of all electrical devices to be connected at one time. This
total should NOT be greater than the generators wattage capacity.
5.2 The rated wattage of lights can be taken from the light bulbs. The rated wattage of
tools, appliances and motors can usually be found on the data label or decal affixed
to the devices.
If the appliance, tool or motor does not give wattage, multiply volts by ampere rating
to determine watts (volts x amps = watts).
5.3 Some electrical induction motors require about three times more power for starting
than for running. This surge of power only lasts a few seconds when starting.
You MUST make sure you allow for high starting wattage when selecting electrical
devices to connect to your generator.
5.4 DO NOT change the voltage changeover switch whilst the engine is running.
5.5 Make sure the electrical apparatus to be powered is turned 'OFF' before plugging
into socket outlet.
14