4. STARTING PROCEDURE
NOTE
Before starting the engine;
DO NOT connect any electrical appliance to the machine.
Check fuel and oil levels are correct.
4.0
Turn the fuel tap to the 'ON' position (1).
4.1
Turn the engine switch to the 'ON' position (2).
4.2
Slide the choke lever to the 'START' position (3).
NOTE: This procedure is not required if the engine is already warm.
1
4.3
Pull the recoil starter handle (1) slowly until resistance is felt and then pull the handle
up swiftly.
4.4
After starting, allow the recoil starter handle to return to its original position while still
holding the handle.
4.5
Allow the engine to warm up.
4.6
Turn the choke lever back to the 'RUN' (2) position.
1
4.7
Continue to allow the engine to warm up for a few minutes without load.
2
13
3
2