Select a good location. Place your freezer
where it is easy to use.
Avoid placing the unit near heat sources,
direct sunlight or moisture.
To avoid vibration, the unit must be leveled.
If required, adjust the leveling screws to
compensate for the uneven floor. The front
should be slightly higher than the rear to aid
in door closing. Leveling screws can be
turned easily by tipping the cabinet slightly.
Turn the leveling screws counterclockwise
) to raise the unit, clockwise (
Clean your freezer thoroughly and wipe off
all dust accumulated during shipping.
Install accessories such as ice cube box, etc.,
in their proper places. They are packed
together to prevent possible damage during
Connect the power supply cord (or plug) to
the outlet. Don't double up with other
appliances on the
Product with handle
shall be located at
least 55 mm from the
wall on the hinge side
to open door by 90°
The warm air under
bottom and rear side
of the product have
to release. Otherwise,
This will increase the
Appliance usage range
This appliance is intended to be used in
household and similar applications such as
– staff kitchen areas in shops, offices and other
– farm houses and by clients in hotels, motels
and other residential type environments;
– bed and breakfast type environments;
– catering and similar non-retail applications.
When your fridge is installed, allow it 2-3 hours
to stabilize at normal operating temperature
prior to filling it with fresh foods.
If power plug is disconnected, allow 5 minutes
delay before restarting. Your fridge is now ready
The appliance is designed to operate at the
limited range of ambient temperature,
depending on climate zones.
Do not use the appliance at the temperature out
of the limit. Climate class of your appliance is
indicated on the label with technical description
inside the fridge compartment.
+10 ~ +32
+16 ~ +32
+16 ~ +38
+16 ~ +43
+10 ~ +43