Eol Jumper Settings - Honeywell SC105 Installation & User Manual

Settings

EOL Jumper Settings

* Factory default settings are shown in grey.
J19/J20 Settings
* Factory default settings are shown in grey.
J1 Setting
J1 is used for remote test, and for all the information, please see
page 16.
- 14 -
Jumper
TAMPER
(RT)
ALARM
(RA)

Refer to Control Panel manual for proper EOL selection.

For each block, only one EOL value can be set.
Note

Other EOL resistor values can be used by removing all jumpers on the EOL jumper field
and wire new resistors directly on the terminal block.
No Jumper
Terminal 8 = Spare Terminal
J19
Connect SC111/SC112 to the loop
J20
Position
1-2
2-3
4-5
5-6
1-2
2-3
4-5
5-6
Jumper
Terminal 8 = Alarm O/C Output
Normal Close
EOL Value
1K
2.2K
4.7K
5.6K
1K
2.2K
4.7K
5.6K
on
Remote Test (Alternative)