EOL Jumper Settings
Jumper
TAMPER
ALARM
* Factory default settings are shown in grey.
J19/J20 Settings
J19
J20
* Factory default settings are shown in grey.
J1 Setting
J1 is used for remote test, and for all the information, please see
(RT)
(RA)
Refer to Control Panel manual for proper EOL selection.
For each block, only one EOL value can be set.
Note
Other EOL resistor values can be used by removing all jumpers on the EOL jumper field
and wire new resistors directly on the terminal block.
No Jumper
Terminal 8 = Spare Terminal
Connect SC111/SC112 to the loop
Position
1-2
2-3
4-5
5-6
1-2
2-3
4-5
5-6
Jumper
Terminal 8 = Alarm O/C Output
Normal Close
Honeywell
EOL Value
1K
2.2K
4.7K
5.6K
1K
2.2K
4.7K
5.6K
on page 22.
Remote Test
- 19 -