Installation - Honeywell SC105 Installation & User Manual

6 Installation

Mounting the Detector
Mini-Seismic Vibration Detector SC105 can be mounted on solid surfaces, of which the most
common surfaces are Steel, Stainless Steel and Hardened Steel.
Opening the Detector
Before mounting the detector, loose the top screw to separate the detector cover from the
detector base.
Figure 6-1 Opening the Detector
Mounting on Steel
When mounting the detector on a flat and smooth steel surface, both Drill Plan (see
Drill
mounting holes.
Figure 6-2 Drill Plan
Refer to the steps below to mount the Detector SC105 on steel.
1. Attach the Detector Base or Dill Plan on the mounting area, and then mark the outline and
2. Remove the Drill Plan or Detector Base, and then thoroughly remove the paint in the
Note:
A

Please read
TO THE INSTALLER

Before the installation is finished, make sure the sensitivity setting is correct and the
Caution
noise level is considered.

Detector should not be mounted on cinder block or other unproved masonry surface.
Plan) and Detector Base (see
A
Note Please remove the drill :
plan after mounting holes
have been drilled
center punch the detector mounting holes A, B and test transmitter mounting hole C.
outline marked on the mounting area.
The remnant Drill Plan or paint will weaken the sensitivity badly.
B
first before mounting the detector.
The top screw is only
Note:
used for fixing the cover, so
do not tighten it too much
when mounting the detector.
Description) can be used to mark the
Figure 2-1 Detector
C
A, B - Detector SC100 mounting hole
C - Test Transmitter SC113 mounting hole
The drill plan shall be
Note:
removed after all of the
mounting holes have been
drilled.
B
Notes:
 Detector base cannot be used to
mark test transmitter mounting
hole C.
 Skip marking hole C if no Test
Transmitter SC113 is used.
Honeywell
Figure 6-2
C
A
B
- 9 -