Motorola MTM800 Feature User Manual page 86

1. From the menu, select 1 Keylock. All keys are locked
except the On/Off key.
When there is an incoming call and the keypad is locked, you
can still use PTT,
2. To unlock the keypad, press
The Emergency Key is not locked.
unlocks all keys.
PIN Protect (
Menu
Network access protection is configured by your Service
Provider:
No access to network operation — you can only send or
receive Emergency Calls. Unit lock takes effect at the next
power on.
To protect access to network operation:
1. Press
2. Select 1 On to set the protection (or 2 Off to cancel it).
3. At the Code? prompt enter the 4-digit code (factory setting
is "0000"). To avoid disclosure of the PIN, asterisks are
displayed instead of the code digits. Press Ok. The display
will show one of the following messages:
Unit Locked — you entered the correct code. The display
returns to the Security sub-menu and shows the active
setting: 1 On.
Unit Unlocked — you entered the correct code. The
display returns to the Security sub-menu and shows the
active setting: 2 Off.
To unblock the MTM800 after powering on, enter the code at
the prompt. The MTM800 enters the default home mode.
If you fail to enter the correct code, the following message will
be displayed:
Incorrect Code Entered — You are prompted to try again.
After failing three times, your MTM800 will be blocked.
80
3 2)
- 3 Security - 2 PIN Protect.
Menu
, and Reject.
3 1.
Menu
Entering Emergency Mode,