Motorola MTM800 Feature User Manual page 49

2. Scroll to 1 MS - MS and press Ok. The
following message to be displayed for a
few seconds: MS - MS Will Be Used.
Selecting
DMO Group Call via Gateway
While in DMO, proceed as follows to choose a gateway to set
up a call via Gateway for the selected talkgroup:
1. Press Optns, scroll to 3 Config, and press Ok.
2. Scroll to 2 Gateway and press Ok.
3. The display shows the last gateway selection method. Use
the navigation key to scroll to your selection and press Ok:
Automatic
first available gateway for that talkgroup.
The Gateway icon will flash upon
selecting that option.
Specific
specified Gateway address for that talkgroup.
Upon selecting "Specific", you will see one of the following
displays:
• The selected gateway address (e.g.:
1022), pre-programmed by your
Service Provider or previously
entered by yourself via the keypad.
Press Ok to use the current address, or enter a new
address via the keypad, and press Ok. The Gateway
icon will flash upon selecting the gateway.
• "None", indicating that no gateway
was selected for that talkgroup. Enter
an address via the keypad, and press
Ok. The Gateway icon will flash upon
selecting the gateway.
the MTM800 will use the
—
the MTM800 will use only the gateway with the
—
4 GW + Rep
1 MS - MS
2 Gateway
Back Ok
1 MS - MS
2 Gateway
3 Repeater
Back Ok
1 Automatic
2 Specific
Back Ok
GW No: 1022
Will Be Used
Selected GW:
None
Back Ok
43