Gram / Ounce Selection - Ranger DST-2420 Installation And Operation Manual

For balancing automobile, motorcycle & light truck tires / wheels

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

SELECTING WEIGHT POSITIONS

FOR DIFFERENT WHEEL TYPES

Prior to balancing, a specific FUNCTION must

be chosen for each particular wheel. The

function settings automatically compensate

weight location requirements for a particular

wheel type. These settings can be selected by

depressing the F button.

DYNAMIC

For balancing standard steel or alloy wheels using

clip-on weights attached to inner and outer wheel edges.

Static

This function is used if weights can only be

mounted on a single plane of the wheel.

ALU1

This function is used if stick-on weights are

to be mounted to both inner plane and outer

planes of the wheel.

ALU2

This function is used if stick-on /clip on

weights are to be mounted to the inner edges

and stick on weights are to be mounted on

the center planes of the wheel.

ALU3

This function is used if stick-on weights are

to be mounted to the inner plane of the wheel

and clip-on or stick weights are to be mounted to the outer

edge of the wheel.

This machine is capable of registering GRAM or OUNCE

readings. To select either GRAM or OUNCE settings, follow

the procedures below.

1. First press the "STOP" button.

Then press the Distance

the same time.

The weight readings will change in the INNER and OUTER

windows to register the applicable setting.

(No Symbol Illuminated)

To select either MM or INCH measurement reading for the

"L" WHEEL WIDTH setting, follow the procedures below.

1. First press the "STOP" button.

Then press the WIDTH

same time. The weight readings will change in the INNER

and OUTER windows to register the applicable setting.

To select either MM or INCH measurement reading for the

"dia" WHEEL DIAMETER setting, follow the procedures

below.

1. First press the "STOP" button.

Then press the DIAMETER

at the same time. The weight readings will change in the

INNER and OUTER windows to register the applicable set-

ting.