Ranger DST-2420 Installation And Operation Manual page 14

2. After the hood is lowered, or the START button is
depressed, the wheel will spin for approximately six
seconds then stop automatically.
3. After the wheel stops, weight readings for each side of the
wheel (INNER and OUTER) will appear in the center display
screen.
4. Turn the wheel by hand until the weight position indicator
lights on the side marked INNER are FULLY ILLUMINATED.
This indicates the position specified by the balancer for the
inner weight position.
5. Attach the specified weight for the appropriate PLANE
position at top-dead-center.
To hold the wheel in position when installing weights,
press down on the TIRE STOP PEDAL located on the
right side of the machine.
All weight positions are located at TOP-DEAD- CENTER.
The more accurate you are in selecting the exact weight
and position, the more accurate the wheel will be
NOTE:
NOTE:
balanced.
6. After the INNER weight is properly installed, turn the
wheel by hand until the weight position indicator lights on
the side marked OUTER are fully illuminated. This indicates
the position specified by the balancer for the OUTER weight
position.
7. Attach the specified weight for the appropriate PLANE
position at top-dead-center.
Perform the Trouble Shooting and Calibration
Procedures on page 16 and 17 if you are experiencing
balancing problems.
It is recommended to perform the Weight Location
Verifi cation on a monthly basis following procedure that can
be found on page 17 in the manual.
14
NOTE:
NOTE: