Ranger DST-2420 Installation And Operation Manual page 4

IMPORTANT SAFETY INSTRUCTIONS!
Protective goggles, safety glasses, or a face shield
must be worn by the operator. Care should be taken to
see that all eye and face safety precautions are followed
by the operator. ALWAYS WEAR SAFETY GLASSES.
Keep guards and safety features in place and in
working order.
Wear proper protective clothing. Safety toe, non-slip
footwear and protective hair covering to contain hair is
recommended. Do not wear loose clothing, or jewelry
when operating the balancer.
If an extension cord is necessary, a cord with a
current rating equal to or more than that of the equipment
should be used. Cords rated for less current than the
equipment may overheat. Care should be taken to arrange
the cord so that it will not be tripped over or pulled.
Do not disable hood cover operation, or in any way
shortcut safety controls and operations.
Be sure that all wheels are mounted properly, the hub
nut engages the arbor for not less than four turns, and the
hub nut is firmly tightened before spinning the wheel.
Read and understand this manual before operating.
Be sure the balancer is properly connected to the
power supply and electrically grounded.
Do not operate damaged equipment or if the power
cord is cut or worn.
Keep work area clean and well lighted. Cluttered and/
or dark areas invite accidents.
Avoid dangerous environments. Do not use power
tools or electrical equipment in damp or wet locations, or
expose them to rain and moisture.
KEEP ALL INSTRUCTIONS PERMANENTLY WITH UNIT
AND ALL SAFETY DECALS CLEAN AND VISIBLE !
THE SELECTOR SWITCH ON THIS EQUIPMENT IS SET FOR 220 VAC.
For use with 220 current, attach appropriate plug head for your outlet.
It is recommended to operate the Balancer on 220Volts for optimum performance.
READ BEFORE OPERATING UNIT!
For use with 110 VAC, change Selector Switch to 110 VAC,
then attach appropriate plug head for your outlet.
Avoid unintentional starting. Be sure the balancer is
turned off before servicing.
Disconnect the balancer before servicing.
Use only manufacturer's recommended accessories.
Improper accessories may result in personal injury or
property damage.
Repair or replace any part that is damaged or worn
and that may cause unsafe balancer operation. Do not
operate damaged equipment until it has been examined
by a qualified service technician.
Never overload or stand on the balancer.
Do not allow untrained persons to operate machinery.
To reduce the risk of fire, do not operate equipment in
the vicinity of open containers or flammable liquids.
Adequate ventilation should be provided when
working on operating internal combustion engines.
Keep hair, loose clothing, fingers, and all parts of
body away from moving parts.
Use equipment only as described in this manual.
Use only manufacturer's recommended attachments.
DAMAGE CAUSED BY STRIKING OR HITTING THE
QUICK-NUT WITH HAMMER, TIRE IRON OR HEAVY
OBJECT IS NOT COVERED UNDER WARRANTY!
IMPORTANT !
4
CAUTION!