Terraillon Tensio Instruction Manual page 18

Wrist blood pressure monitor

Hide thumbs Also See for Tensio:

Available languages

BLOOD PRESSURE MONITOR – INSTRUCTION MANUAL

MEASUREMENT

Tie the Cuff

1. Remove all accessories (watch, bracelet, etc) from your wrist. If your physician

has diagnosed you with poor circulation in your wrist, use the other one.

2. Roll or push up your sleeve to expose the skin.

3. Apply the cuff to your wrist with your palm facing up.

4. Position the edge of the cuff about 1-1.5cm

5. Fasten the wrist cuff around your wrist, leaving no extra room between the cuff and your skin. If the cuff

is too loose, the measurement will not be accurate.

• Rest for 5 minutes before measuring.

• Wait at least 3 minutes between measurements. This allows your blood circulation to recover.

• For a meaningful comparison, try to measure under similar conditions.

Start the Measurement

1. Before you start measurement, select the desired user-ID first. Hold MEM button until the user-ID

blinks. Then, press MEM button to change the user ID between 1 and 2. Press SET button to confirm

your selection. Then the LCD will turn off.

2. When the monitor is off,press the "START/STOP button to turn on the monitor, and it will finish the

whole measurement. And save the measurement data.

(1) LCD display

(2) Adjust to zero

(3) Inflating and measuring

(4) Display and save

the measurement result

DAT