Terraillon Tensio Instruction Manual page 17

Wrist blood pressure monitor

Hide thumbs Also See for Tensio:

Available languages

BEFORE YOU START

Installing and Replacing the Batteries

• 2×AAA batteries (Not Included)

• Open the battery cover

• Install the batteries by matching the correct polarity, as shown

• Replace the cover

Replace the batteries whenever the below happen

• The

CAUTION

Remove batteries if the device is not likely to be used for some time. The old batteries are harmful to the

environment; do not dispose with other daily trash. Remove the old batteries from the device and follow

your local recycling guidelines. Do not dispose of batteries in fire. Batteries may explode or leak.

Setting Date, Time and Measurement Unit

It is important to set the clock before using your blood pressure monitor, so that a time stamp can

be assigned to each record that is stored in the memory.

1. When the monitor is off, hold pressing "SET" button for 3 seconds to enter the mode for year setting.

Or when the monitor is off, press "SET" button shortly, it will display the time. Then hold pressing "SET"

button to enter the mode for year setting. Note: "MEM" button allows you to change the data, "SET"

button allows you to confirm the data.

2. Press "MEM" button to change the [DAY].

3. When you get the right day, press "SET" button to set down and turn to next step.

4. Repeat steps 2 and 3 to set the [MONTH] and [YEAR].

5. Then the monitor diverts to time setting. Select the time format. Repeat steps 2 and 3 to confirm the time

format, between 12h and 24h.

6. Repeat steps 2 and 3 to set the [HOUR] and [MINUTE].

7. Repeat steps 2 and 3 to set the [UNIT].

8. After the unit is set, the LCD will display all the settings you have done and then it will turn off.

BLOOD PRESSURE MONITOR – INSTRUCTION MANUAL

shows

• The display dims

• The display does not light up