Telnet Connection - Alcatel 7450 ESS-7 Installation Manual

Establishing Connections
T C
ELNET ONNECTION
Access the switch after a successful initialization with a Telnet connection from a PC or
workstation connected to the network after the management port
using the
and administrator access as those available through the console port.
To configure the 7450 ESS-7 for Telnet access, you need to have a device with Telnet software
located on the same network. The 7450 ESS-7 must have a management IP address. The IP
address is manually configured. Each 7450 ESS-7 switch is limited to a total of 7 Telnet or SSH
sessions. For information about configuring switch parameters, refer to the 7450 ESS-7 OS System
Guide. For pinout information, refer to
MAC addresses are listed on a small label on the chassis, IOM, and MDA. The MAC address also
displays in the
CLI Syntax: bof
The 7450 ESS-7 must have a management IP address. The IP address is manually configured.
Page 90
command (see below). Telnet access provides the same options for user
bof>address
show router arp
Figure 31: Management Port Connection
address ip-address/mask [active|standby]
Appendix C: Pinout Assignments on page
command output.
Mgmt Port
(Figure 31) has been configured
149.
7450 ESS-7
ESS1005