Attach Accessory Drawer To Table Cabinet - Well Universal SWS221521 Assembly Instructions Manual

ASSEMBLY INSTRUCTIONS
2A. -Attach Accessory Drawer to Table
Cabinet
With assistance from another adult, place the
Accessory Drawer (3) onto Table Cabinet (1)
as shown in FIG. 2A. Make certain that the
notch in the Accessory Drawer fits completely
down onto the support beam on the bottom of
the Table Cabinet as shown in the close up in
FIG. 2A.
2B. -Attach Accessory Drawer to Table Cabinet
With assistance from another adult, press down on
the back corners of the frame of the Accessory
Drawer (3). While holding the Accessory Drawer
in place by pressing down on the back corners of
the frame, pull the Accessory Drawer completely
out. Then, insert a Short Bolt (B), Spring Washer
(C) and Flat Washer (D) through the holes in the
triangle shaped boards in each corner of the
drawer to attach the drawer to the Table Cabinet
as shown in the close up in FIG. 2B. Tighten
slightly using the Hex Wrench (E), but DO NOT
tighten bolts completely at this time as slight
adjustments will need to be made later.
Next, use Long Bolts (A), Spring Washers (C) and
Flat Washers (D) to further attach the Accessory
Drawer to the Table Cabinet. There are three
pre-drilled holes on each side and two pre-drilled
holes on the back of the frame of the Accessory
Drawer through which these bolts are inserted.
Please see close up in FIG. 2B.
Completely tighten the two Long Bolts in the back
of the drawer frame first. Then, tighten all
remaining bolts (including those in the triangle
shaped wood boards in the corners) completely
using the Hex Wrench (E). Once all bolts are
tightened completely, carefully close the drawer.
Hardware Used
0
LONG BOLT
~
x4
0
SHORT BOLT
ID-
x6
G
SPRING WASHER
©>
x10
G
FLAT WASHER
@
x10
G
HEX WRENCH
~
X
1
5
Press the corners
of the drawer to
help hold it in the
correct position.