Mounting The Attachment For Table Tray - Invacare Rea Dahlia 30 Service Manual

Rea® Dahlia® 30 / 45

2.6 Mounting the attachment for table tray

1.
B
A
Mount the table attachment A with the attachment part
facing outwards. The plain surface B of the attachment
should be placed upwards when using the table on the
thin armrests.
2.
C
To fit the table attachment A to the wide armrest, turn
the attachment around, the patterned surface C should
now be facing upwards.
2.7 Mounting the table tray
A
Mount the table tray A in the table tray attachments B.
2.8 Mounting the half tray
Mounting the half tray
1. Insert the tube of the half tray A into the attachment
B under the arm pad.
2. Push on the push pin C and insert the ring D on the
tube A.
3. Release the push pin C.
8
A
B
B
A
2.9 Mounting the posture belt
Belts/harnesses which are CE-marked for the purpose
of using on wheelchairs, can be mounted on the
chair with preserved CE-marking. The belt/harness
should be fitted by the responsible prescriber and be
mounted by an experienced technician. However,
when transporting the wheelchair in a vehicle,
Invacare's original pelvic belt must be used as a
complement to the safety belt in the vehicle!
The posture belt is used to prevent the risk of falling
or sliding out of the chair and for providing the user
with a good posture.
The posture belt C is mounted on the backrest brackets A.
1. Thread the posture belt through the mounting on the
chair and then through the two plastic buckles as shown
in picture B.
2. Thread the posture belt through both of the plastic
buckles.
2.10 Mounting the rear wheels
1. Press and hold in the quick-release button A.
2. Place the rear wheel axle B in the rear wheel
attachment C.
3. Pull the wheels outwards to check that the wheel is
securely locked in position.
WARNING!
Risk of injury
– Check that the rear wheel is securely locked in
position! It should not be possible to remove
the wheels when the quick-release button A
is inactivated.
A
B
C
C
A
1572308-G