Dimmer Setting - HDL -MPT4-RF.18 User Manual

User Manual
HDL-MPT4-RF.18

7. Dimmer Setting

Dimmer Turnoff Temperature:
Set the temperature for protection, when the panel's detected temperature reaches to the
setting temperature, it will turn off the connected loads automatically. When the detected
temperature is lower than the setting temperature, it will restore the loads' status again.
Dimming brightness save:
It can restore the 'channels' status before power off'.
Save: Save the channels' statuses which have lasted for at least 20 seconds before
power failure, and restore the status when power on.
Don't save: Do not save the channels' statuses before power failure, and all channels will
OFF when power on.
Dimmer Address information:
It shows the address for power interface module. Channel no. 1-3 is for address1,
channel no. 4-6 is for address2, channel no. 7-9 is for address3, channel no. 10-12 is for
address4.
If one power interface module's address is 3, and you want to control 3 channels of this
power interface module, you need to control channel 7 to 9 of the wireless panel.
16
Wireless 4 buttons Touch Panel – User Manual