Basic Setting - HDL Prism Lite Series User Manual

Click "Basic Information" in configuration page, as shown in Figure 2-1. This page includes
the following setting options:
① Indicator Intensity: includes status indicator (button indicator) brightness adjustment.
② Press time setting: includes the time setting of long press.
 Long Press: Keep pressing the button longer than the time period, and the system
will identify as "Long Press". The range is from 0.3s to 25s.
③ Min. dimming value setting: means the minimum dimming value. The light brightness will
not fall under this value during dimming operation.
④ Analog information setting: to enable/disable timing analog broadcast, or read panel
voltage.
⑤ Broadcast temperature: Built-in temperature probe in Tile Panel enables temperature
detection. The temperature data can be broadcast to corresponding device if the Subnet
ID and Device ID is set. The temperature data can be adjusted with the slider.
⑥ Standby display and page setting:
 Always ON: enable keeping the panel on
 Eco mode: to enable the panel to enter eco mode automatically. If enabled, the delay
time and indicator standby brightness can be set behind.
 Proximity sensor enable: to enable the proximity sensor of Prism Panel
 Click sound: to enable button sound
 Proximity sensor trigger key: to trigger target when the panel senses human body.
 Proximity sensor sensitivity: to set the sensitivity of proximity sensor, and higher value
means the sensor is more sensitive.
HDL Automation Co., Ltd.
http://www.hdlautomation.com
Prism Lite Series Touch Panel User Manual

2 Basic Setting

3