Software Configuration - HDL -MPT4-RF.18 User Manual

User Manual
HDL-MPT4-RF.18
Wall box: For convenience of the wiring installation, the wall box should be a little deeper
than the power interface.

5. Software Configuration

5.1 Basic Information
5.1.1 Wireless Setting via Mesh Gateway
Before user can configure the wireless panel normally, need to set the wireless
parameters for it via mesh gateway, and the mesh gateway needs to work in mesh mode.
1- Set the free frequency and unique PSK PWD for the gateway
2- Press the 'PROG' button 3 times continuously, the red LED will flash quickly that means
the gateway enters the wireless setup mode.
3- Long press any button of panel about 25s (at the 15s, the LED will flash quickly that
means it enters the address modify mode), the LED will flash slowly.
4- Click the 'Search' button, this panel will be shown as below.
4
Wireless 4 buttons Touch Panel – User Manual