Russell Hobbs RH90FF176-WD Instruction Manual page 17

Water Dispenser
Cleaning & Assembly
Using a flat headed screwdriver, gently insert it between the raised edge(s) of
the water valve and dispenser moulding. Then slowly and carefully raise the
edges with screwdriver on either side of the water valve, the water valve should
lift and be removed by hand at a 45º angle.
Clean all parts (water tank and cover, seal ring and water valve with hot soapy
water, then rinse thoroughly and dry.
The water dispenser can be cleaned by dispensing hot soapy water through it,
however you must ensure to flush the hot soapy water away by dispensing at
least 6 large cups of clean water through the dispenser.
It is recommended to clean the water tank, seal ring, water valve and the
dispenser in this way at least once a month.
Note: The tank must be cleaned and dried regularly in order to avoid the
overflow water spilling on to the appliance or the floor. Any spillages on the
appliance or on the floor must be cleaned up immediately.
For Customer Services & Spare Parts please call 0345 208 8750
Opening times: Monday - Friday 8am – 8pm & Saturday 9am – 1pm
or visit us at www.productcare.co.uk
17