Stamina InMotion II 45-1002C Owner's Manual page 11

OPERATIONAL INSTRUCTIONS
WALKING RESISTANCE
The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline
angle. This treadmill has two adjustment positions.
Highest Resistance
The BUMPER STANDS(22) are attached to
the bottom of the treadmill.
NOTE:
1. Since this is a new machine, you may need some time to get used to walking on the treadmill and to
break it in.
2. If the walking resistance is too high, check the BELT TENSION. Refer to page 10 for instructions to
adjust belt tension.
3. The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe
the board under the belt with a clean, dry cloth then spray or spread silicone lubricant on the board
under the belt.
MAINTENANCE
The safety and integrity designed into the InMotion® II Treadmill can only be maintained when the
InMotion® II Treadmill is regularly examined for damage and wear. Special attention should be given to
the following:
1. Clean the exposed surfaces of the WALKING BELT(17) and the BOARD(18) with an absorbent cloth.
2. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
3. Verify that the SPRING PIN(6) is present and functioning properly. Verify that the BALL KNOB(8) is
securely attached to the SPRING PIN(6). Repair or replace parts as necessary.
4. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten
loose nuts and bolts.
5. Verify that the CAUTION LABEL(54) is in place and easy to read. Call Stamina Products immediately at
1-800-375-7520 for a replacement CAUTION LABEL(54) if it is missing or damaged.
6. Worn or damaged components shall be replaced immediately or the InMotion® II Treadmill removed
from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the InMotion® II Treadmill.
8. Keep your InMotion® II Treadmill clean by wiping with an absorbent cloth after use.
9. If the WALKING BELT(17) does not move easily, lubricate the BOARD(18) under the WALKING BELT(17)
with Silicone Lubricant.
Lowest Resistance
Remove (unscrew) the BUMPER STANDS(22)
from the bottom of the treadmill and store them
in the end of the treadmill.
11