weinor BiEasy Box Operating Manual page 6

BiConnect BiEasy Set
2 S afety instructions
1 B 1 B
Keep unauthorised persons away from the unit until it is ready for use.
•
The connected electrical load must tally with that listed in the technical data.
•
The regulations of the local energy providers and the VDE 0100 provisions for humid and wet
•
areas must be observed.
Only connect the remote receiver to devices approved by weinor.
•
This device is not to be used by people (children included) with limited physical, sensory or
mental abilities or who lack the required experience and / or knowledge unless they are
accompanied by someone responsible for their safety or have been properly instructed in the
use of the device.
Never allow children to use electrical devices without supervision.
•
2.1 G eneral safety instructions
1 5 B 1 5 B
This operating manual contains all safety instructions which must be observed for the prevention
and averting of hazards while handling the device in connection with the controllable drives and
components. The safe use of the device is guaranteed if all the safety instructions listed are
adhered to.
2.2 R equirements for personnel
1 6 B 1 6 B
Every person who is instructed to work with the device must have read the complete operating
manual and understood the resulting hazards before he carries out the respective work.
2.3 S afety instructions for operation
1 7 B 1 7 B
Check the housing and the cables for damage both before the initial start-up and subsequently
at regular intervals. Never start up a damaged device.
2.4 D anger due to electricity
1 8 B 1 8 B
Work involving connections to 230 V mains may only be carried out by a trained electrician.
•
Disconnect the unit from the power supply before performing any work.
•
weinor recommendation: a residual current circuit breaker (trip switch) should also be fitted to
•
protect the indoor installation.
Item number 117445-0000
Version 1 15.11.2013
Subject to technical modifications
Page 6/23
Main Operating Manual