weinor BiEasy Box Operating Manual page 19

BiConnect BiEasy Set
5.2 D eleting a transmitter channel from the receiver
2 8 B 2 8 B
There is no provision for the entire deletion of all dispatchers in the receiver. A separate
hand transmitter must be used for this function.
Deleting individual channels:
1. Select the channel you wish to delete.
2. Press and hold down the UP, STOP-/P and DOWN keys at the same time for at least 6
seconds.
3. The status display will flash briefly.
The channel has now been deleted from the dispatcher.
6 M aintenance and repairs
5 B 5 B
DANGER
Electric shock!
Work involving 230 V mains may only be carried out by a trained electrician.
Disconnect the unit from the power supply before performing any work.
Danger of injury due to electric current!
6.1 M aintenance of radio receiver
2 9 B 2 9 B
If a component does not react as expected, you must check the connections.
If you have any questions, please contact your specialist retailer.
Please always indicate the following:
Article number and article name from the type plate
•
Type of error
•
Previous and unusual incidents
•
Attendant circumstances and your presumption on the occurrence of the error
•
6.2 P ower supply
3 0 B 3 0 B
Only make changes to the wiring method of the BiEasy Box when the power is switched
•
off or without a connection to a live power socket.
Underneath the BiEasy Box, you will find concealable connection contacts with retention;
•
these are used for the connection of the different adapters (country-specific or with small
device power connection cable).
Select and connect one of the enclosed plug adapters for the power supply.
•
Slide the plug adapter at the rear of the BiEasy Box to the connection contacts. If
•
required, disconnect by applying pressure on the retention of the plug adapter.
The left status display signals the readiness for operation by the long-lasting shining of a
•
green light for some time after the the power connection has been established.
7 C leaning and care of the device
6 B 6 B
Use a soft, clean and dry cloth only to clean the outer surface of the device.
•
Avoid using chemical solvents and detergents because these could damage the surface
•
and/or the labelling of the device.
Item number 117445-0000
Version 1 15.11.2013
Subject to technical modifications
Page 19/23
Main Operating Manual